Invert the fork tubes and pump the tubes up & down to pump the old fork oil out and let drain for a couple of minutes in a drain pan. Add 12.5 to 15wt. fork oil which will be measured from the top of the oil level to the top of the fork leg. (approx. 150mm), it took a little more than 1 qt. per leg on mine. Reassemble the internals and and snug View and Download Honda CBF1000 owner's manual online. Honda. CBF1000 motorcycle pdf manual download. Also for: Cbf1000a. Yeah replace the dust and oil seals and run 5-10w oil in the forks. Lube the seals when replacing them that way they slide on easier and no damage occurs. 02 F4i track build-fully built motor, 600rr swinger and rear master, 1000rr front end and rear shock, akra full exh, pcIII and ign module, HRC radiator and quick throttle, brembo fr master Seventh Generation VFR's. Got my 2010 VFR1200FD a couple months ago, and during that time the forks started leaking oil. I tried to fix them with a SealMate, but it just didn't work. So, time to swap out the fork seals. I've never had to do them before, but I watched a few vids. Easy enough. Hi Mark, I haven't found the info in the 2016 owners manual, but found it from 2 different sources. FORK OIL CAPACITY: CB500X/XA: 453 ± 2.5 cm3 (15.3 :::: 0.08 US oz, 15.9 ± 0.09 Imp oz) FLUID LEVEL: CB500X/XA: 160 mm (6.3 in) it's 10W oil. I think you'll find articles written by JMo with the same capacity used. 5wt oil is what is specified by Aprilia for the Ohlins forks. Measure your air gap to set the oil level, do not rely on measuring the volume of the oil you put in because most of the time there is still going to be some old oil remaining in the cartridge. You can set the air gap between 80 and 110mm depending on how you want the air spring to I put in fork seals in my 2007 150r and cant find how much oil is in each fork along with measurements. Any help would be appreciated. FORK FLUID CAPACITY:290+/-2.5cm3 (9.8+/-0.08 US oz, 10.2+/-0.09 Imp oz) I was wondering does it matter how much the top of the fork sticks out of the triple crown. No, as long as the clamps are 100% on the forks Today I picked up my new CRF110 2019/2020 (Not sure if it is 2019 of 2020, but that will be another post), originally Honda always puts break-in oil in the engine to run with for the first hour, hour-and-a-half. .

honda varadero 1000 fork oil capacity